lock actuator setup

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62271
Printed Date: July 19, 2025 at 3:23 PM

Topic: lock actuator setup

Posted By: maxedmini
Subject: lock actuator setup
Date Posted: September 06, 2005 at 8:54 AM

hi all if at all posible can someone explain how to do the following

ok i have a 5 wire actuator and i have a - pulse from my alarm.
what i need to do is when the when the actuator gets the - pulse (0.5 seconds) i need it to fully extend then fully contract.

is there any what this can be done.???

if posible a diagram would be great

Replies:

Posted By: ringojam
Date Posted: September 06, 2005 at 11:24 AM

explain why you need it to do this what application are you using it for?

Posted By: maxedmini
Date Posted: September 06, 2005 at 11:55 AM

hi there currently i have it to pull the leaver that opens the door but i need it to pull one way to open it then back so the door will close

currently i use a spring to return the actuator but would be alot better it it would be powered on the return

Posted By: maxedmini
Date Posted: September 07, 2005 at 1:45 AM

ok sorry sould have said its used to open the door not unlock the door

Print Page | Close Window