compustar light output

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62291
Printed Date: July 13, 2025 at 12:30 AM

Topic: compustar light output

Posted By: six2six
Subject: compustar light output
Date Posted: September 06, 2005 at 5:14 PM

I have a 97 Mazda 626 with LED turn signal mirrors. I was wondering if anyone knows how I can hook up my Compustar park light output to the mirrors? Right now the mirrors are hooked up to the left and right turn signal output wire at the flasher unit under the dash. Any info on this will be greatly appreciated. Thanking you in advance.

Replies:

Posted By: six2six
Date Posted: September 07, 2005 at 10:05 PM

can anyone help me out?

Posted By: saleengt
Date Posted: September 08, 2005 at 6:23 PM

well most likley your mirrors just require positive and ground..so im sure if you run a positive signal from your compustar park light it should flip them on when it give a positive brake light signal

Posted By: six2six
Date Posted: September 08, 2005 at 10:03 PM

thought of that but the mirrors are hooked up to the flasher unit which also puts out a positive signal to make the mirrors blink with the turn signals. would that cause a problem.

Posted By: saleengt
Date Posted: September 09, 2005 at 4:33 PM

dioide isolate the wire from the brain so the brain cant get feedback from your flasher..id wire it up past the falser with the diode

Print Page | Close Window