Having a basic knowledge of electronics, I figured I could do an install myself. Just got my Crimestopper 2004TW1 and the wiring looks simple. My problem is finding/accessing the harness which has the wire I need. For example, the door trigger. Do I need to pull the vertical plastic panel out so I can visually verify that I have the right cable or is there a manual which gives the location/route of all of this spaghetti?
p.s. I searched hundreds of posts on this site before posting this.
Thanks,
Ken
-------------
Ken
Constant 12 volts | YELLOW OR YELLOW | IGNITION SWITCH HARNESS |
Ignition 12 volts | RED / LIGHT GREEN | IGNITION SWITCH HARNESS |
Starter | RED / LIGHT BLUE | IGNITION SWITCH HARNESS |
Dome Light | BLACK/ LIGHT BLUE | (+) AT PIN SWITCH |
Trunk Pin Switch | N/A | |
Parking Lamp | BROWN | (+) AT LIGHT SWITCH |
Power Lock | PINK / YELLOW | RELAY BEHIND |
Power Unlock | PINK/LIGHT GREEN | DRIVER HEADLIGHT * |
Negative Pulse Door Locks. * It Is Common For Lock & Unlock Wire Colors To Reverse.
Accessories |
Window Up | D\ YEL P\ YEL/BLK @ MAIN SWITCH | |
Window Down | R/ RED S/ RED / BLK | |
Ign Key Warn | BLACK/ PINK | (-) STEERING COLUMN HARNESS |
Trunk Release | N/A | |
OEM Horn | YELLOW/LT BLUE (-) W/ | CRUISE - DK BLUE (+) W/O-STEERING COL |
Headlights | RED / YELLOW | (+) AT HEADLIGHT SWITCH |
OEM Alarm Arm | N/A | |
OEM Alarm Disarm | N/A | |
Reversal Rest At Ground Power Window Circuit
Remote Start |
Tach Signal | DARK GREEN/ YELLOW | AT COIL * |
Ignition #2 | GRAY / YELLOW | IGNITION SWITCH HARNESS |
Ignition #3 | GRAY / YELLOW | IGNITION SWITCH HARNESS |
Accessory | BLACK/ LIGHT GREEN | IGNITION SWITCH HARNESS |
Neutral Safety | NOT GROUNDING TYPE - | OEM SWITCH OPENS STARTER CIRCUIT |
Brake Light | LIGHT GREEN | (+) AT SWITCH ABOVE BRAKE PEDAL |
Reverse Light | BLACK/ PINK (+) | AT SWITCH ON TRANSMISSION |
Rear Window Defrost | | |
* 2.0L Engine Carburated, Rest Are Electronic Fuel Injection.
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.