starter disable interupt problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62377
Printed Date: July 16, 2025 at 3:20 PM

Topic: starter disable interupt problem

Posted By: saleengt
Subject: starter disable interupt problem
Date Posted: September 08, 2005 at 5:34 AM

I am having trouble making my starter interupt work, I have an impulse 777..anyway I use the output from the alarm when its armed it gives a ground, so that I connect to 85 then I connect 86 to the ignition and 87a to the key side and 30 to the starter side, still for some reason the car will start and same when I tried flipping 87a and 30..which should do nothing anyway, then i figured I just dont have a good enough ground, so I ran another relay to make a better ground, still I had the same problem..any suggestions?

Replies:

Posted By: mo12v
Date Posted: September 08, 2005 at 7:37 AM

SPDT Relay
1 or 2 amp Diode across PIN 86 & PIN 85 with stripe facing PIN 86

Cut Starter wire in half:

PIN 86 & 30 = Ignition switch half of cut wire
PIN 87a = Starter side of cut wire
PIN 85 = Negative Output from Alarm while Armed

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.

Posted By: saleengt
Date Posted: September 08, 2005 at 8:44 AM

hey just want to shout out to mo12v thanks man..wired it up just like you said and man..wish i asked you hours ago..haha i would have saved myself alot of time..well im a memorize that wiring setup..thanks again and thanks you all you on the page...what would we do without www.the12volt.com? ...probably never solve many problems..or take hours and hours doing so...