Print Page | Close Window

DEI 564T - No status light, no anything

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62404
Printed Date: May 09, 2025 at 6:23 PM


Topic: DEI 564T - No status light, no anything

Posted By: dual quad
Subject: DEI 564T - No status light, no anything
Date Posted: September 08, 2005 at 6:00 PM

Just installed a DEI 564T with a 457G on a 2005 Envoy. Reasonably straightforward wiring. Nothing is working though… here's the situation:

  • 457G programmed OK
  • Wiring triple checked (B. pedal, siren, & hood pin not connected yet)
  • B+ and ground to 564T confirmed OK
  • No status light LED response
  • No door lock or unlock response
  • No engine start response

Obviously I’m missing something. Does the transmitter need to be programmed to the receiver? I assumed that this was done at the factory as a default. Any ideas where I should start to troubleshoot?




Replies:

Posted By: dare_ds69
Date Posted: September 12, 2005 at 7:31 PM
well the wire BLACK/ white has to see ground, brake has to see ground in order to do r/s, did you use the diode on the 457g, check the rainbow wires fron the relays the yellow wire has to see 12v when is in ignition, if not you have a bad relay pack.posted_image

-------------
how own your mind, control your life.
MECP certified. always use a DMM




Print Page | Close Window