Print Page | Close Window

97 F150 and Autostart Alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62442
Printed Date: April 29, 2024 at 11:21 AM


Topic: 97 F150 and Autostart Alarm

Posted By: Sierra2700
Subject: 97 F150 and Autostart Alarm
Date Posted: September 09, 2005 at 2:01 PM

Just installed an autostart 2 way alarm system. Problem being, when I get into the truck and begin to drive it the shock sensor will go and the alarm will go off.

The remote start and door locks work fine. The only problem is if you start the vehicle and then open or close a door, or if you tap on the shock sensor (or just shake the car really hard) the alarm will still go off(while the car is running).

I was told that the autostart's use the powered up ignition wire to disable the "alarm" portion of the remote starter. Not sure if this is true or not but it shouldn't matter because the ignition wire is being powered up when I remote start.

Any help anyone?




Replies:

Posted By: thepencil
Date Posted: September 09, 2005 at 3:38 PM
The default is set on Passive Arming.

You will need to make the change to Active Arming instead.



Once disarm with the remote and it see the ignition wire power up I don't see why it will sound the alarm. Remove the shock sensor all together and see if the problem continue.    

-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image




Posted By: blazeronspokes
Date Posted: September 09, 2005 at 5:11 PM
check and make sure that the yellow 12v ignition input on the actual alarm brain is hooked up. it may have an ignition output on the remote start harness and an ignition input on the alarm harness.




Posted By: Sierra2700
Date Posted: November 03, 2005 at 6:25 PM
How do you switch between Active and Passive arming? The manual doesn't seem to say how.





Print Page | Close Window