Using door poppers with alarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62443
Printed Date: April 25, 2024 at 7:52 PM
Topic: Using door poppers with alarm
Posted By: lanman31337
Subject: Using door poppers with alarm
Date Posted: September 09, 2005 at 2:14 PM
Hello, I'm just finishing up shaving my locks and handles, and I installed door solenoids and poppers in my car. In my alarm schematics it shows how to install the alarm with door lock/unlock soleniods, so I was just going to use the same wiring. My question is, it says the wires on the alarm are a negative trigger, so would I hook up the ground to the negative trigger, and the positive to a constant power source for my car?
Replies:
Posted By: lanman31337
Date Posted: September 09, 2005 at 10:07 PM
Yeah, my schematics came with a setup with relays. Could someone answer the question for me please?
Posted By: lanman31337
Date Posted: September 10, 2005 at 7:32 PM
NM, i figured it out. I adapted the door lock wiring to just have the unlock to the solenoids.
Posted By: Mr.Swifty
Date Posted: September 15, 2005 at 3:37 AM
lanman31337 wrote:
NM, i figured it out. I adapted the door lock wiring to just have the unlock to the solenoids.
so does this mean every time you disarm the car both doors pop open???? It may be nice to have the drivers door on the pop with disarm and the passgener door pop with say and aux output. or disarm and one door per aux out?
Posted By: Velocity Motors
Date Posted: September 15, 2005 at 9:20 AM
I use AUX channel 1 for driver's side and AUX channel 2 for the passengerside on the last car that had shaved door handles. The only bad thing about that is that you still have to arm and disarm before and after you open/close the doors.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: gcorrea
Date Posted: September 15, 2005 at 5:07 PM
everyone that installs door poppers (that ive read about) asks the same question. would it be possible to add the selonoids in a drivers door priority configuration using only the lock unlock buttons of the alarm and not use up the other aux channels.on my alarm(k9 classic) it shows how to do the drivers door priority set up, unlock the door hit the unlock again within 5 seconds and unlock the pass. door. is there a wiring diagram on doing this with the selonoids?
-------------
gcorrea
|