Automate AM7 programming

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62455
Printed Date: May 09, 2025 at 8:54 PM

Topic: Automate AM7 programming

Posted By: rwl6935
Subject: Automate AM7 programming
Date Posted: September 09, 2005 at 9:11 PM

Hi, I just had an Automate AM7 remote start/alarm installed by the dealer in my new truck. I'm trying to program the system to arm passively, but can't find anything in the owner's guide that explains how to activate the passive mode, I see everything else but active and passive programming. If anyone could tell me how to do this I would gratly appreciate it-

Thanks, Bob

-------------
"Keep it simple stupid!"

Replies:

Posted By: auex
Date Posted: September 11, 2005 at 8:56 PM

Quit bumping. It is annoying.

At anyrate I see it in the manual, the install manual. It is on page 41 of this

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Posted By: rwl6935
Date Posted: September 12, 2005 at 10:41 PM

Thanks! I don't have the install manual, only the owner's manaul.

Thanks again!
Bob

Print Page | Close Window