Print Page | Close Window

1999 Dodge Grand Caravan Code-alam 425

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62473
Printed Date: May 10, 2025 at 4:32 AM


Topic: 1999 Dodge Grand Caravan Code-alam 425

Posted By: kcjba
Subject: 1999 Dodge Grand Caravan Code-alam 425
Date Posted: September 10, 2005 at 6:22 AM

Hi all

Here are a couple easy questions.

1. Below is the wiring diagram for my door locks however when I test the resistors on the main lock switch in the drivers door they work fine. But when I connected the resistors to the WHITE/ dark green in the white connector under the dash only the unlock works. So where exactly is this other connection suppose to take place. A physical description of the location would be greatly appreciated.

Door LockWHITE/ Dark Green (-) BCM at Fuse Panel 1500 Ohm Resistor 
Door UnlockWHITE/ Dark Green (-) White Connector B58 Connector 250 Ohm Resistor 

2. To control the windows would I need a window control module(outside of building my own)?




Replies:

Posted By: mo12v
Date Posted: September 10, 2005 at 10:15 AM

You may need to use 2 Relays to supply stronger Ground.

Power LockWHITE/ D GREENBOTTOM OF JUNCTION BLOCK TWO
Power UnlockSINGLE WIRE SYSTEMCONNECTORS,ONE ON THE LEFT. ***

*** Single Wire Door Lock System, WHITE/ D GREEN Wire Requires Chassis Ground Thru A 1.5K Ohm Resistor To Lock And Chassis Ground Thru A 249 Ohm Resistor To Unlock.

Also:
Use a Window Roll-Up Module
Reversal Rest At Ground Power Window Circuit



-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.


Print Page | Close Window