Print Page | Close Window

1999 Integra power door lock problem. Need Help!

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=6263
Printed Date: June 06, 2025 at 1:41 PM


Topic: 1999 Integra power door lock problem. Need Help!

Posted By: DuTruo
Subject: 1999 Integra power door lock problem. Need Help!
Date Posted: December 04, 2002 at 10:54 PM

I just got a clifford IntelliVoice IQ installed and now the passenger door lock factory switch does not work, but it will lock when i armed the alarm. I tried taking the driver factory door lock switch and testing it on the passenger door and found out it's not the switch. On the driver side I found out that the middle wire going to the switch is +12 volt and when i tested the passenger side there was no reading on my volt meter, can someone help me? what was wired incorrectly when the alarm was installed?



-------------
Du Truong



Replies:

Posted By: 10nesne1
Date Posted: December 05, 2002 at 12:37 AM

Acura

Integra

1996-2001

Remote Starter Wiring Colors and Notes

Function

Vehicle Color

Location

Start:

BLACK/ WHITE

IGNITION SWITCH HARNESS

Ignition #1:

BLACK / YELLOW

IGNITION SWITCH HARNESS

Ignition #2:

YELLOW

IGNITION SWITCH HARNESS

Ignition #3:

N/A

Accessory:

WHITE/ BLACK

IGNITION SWITCH HARNESS

Brake Light:

GREEN / WHITE (+)

AT SWITCH ABOVE BRAKE PEDAL

Tach Signal:

BLUE

AT DISTRIBUTOR OR TACH TEST CONN. *

Parking Lights:

RED / GREEN (+)

AT HEADLIGHT SWITCH **

Headlights:

RED / WHITE (+)

AT HEADLIGHT SWITCH

OEM Alarm Disarm:

BLUE (-)

AT SECURITY CONTROL MODULE ****

OEM Alarm Arm:

N/A

Diesel Glow Plug:

N/A

N/A

Clutch Bypass Wire:

BLUE/BLACK (-)

AT SWITCH ABOVE CLUTCH PEDAL

Notes:

* Distributor Located On Passenger Side Of Engine. Tach Test Connector Is a 2 Pin GRAY Connector Located On Driver Rear Of Engine On Strut Tower. Tach Wire Also Located In 16 Pin GRAY Connector Above Fuse Block Behind Driver Dash.

Acura

Integra

1996-2001

Alarm and Keyless Entry Wiring Colors and Notes

Function

Vehicle Color

Location

Constant +12 Volts:

WHITE/ BLACK

IGNITION SWITCH HARNESS

Starter Kill:

BLACK/ WHITE

IGNITION SWITCH HARNESS

Ignition +12 Volts:

BLACK / YELLOW

IGNITION SWITCH HARNESS

Dome Lights/Superv:

L GREEN/ RED (-)

14 PIN GRAY CONN. IN DR. KICK PANEL

OEM Horn:

BLUE/GREEN (-)

STEERING COLUMN HARNESS

Power Lock:

BLACK/ WHITE

14 PIN GRAY CONNECTOR IN DRIVER'S KICK

Power Unlock:

BLACK/ RED

PANEL***

Trunk Release:

N/A

CABLE OPERATED

Alarm Input Wire:

L GREEN/ RED (-)

14 PIN GRAY CONN. IN DR. KICK PANEL

Notes:

** RED / BLACK (+) In 18 Pin BROWN Connector In Driver Kick Panel Can Also Be Used For Parking Lights. *** See Note #201- Negative Pulse Door Lock Diagram. **** Security Control Module Located on Driver's Side Of Vehicle Right Of Steering Column.



Posted By: DuTruo
Date Posted: December 05, 2002 at 10:38 AM
What is alarm input wire? is that where i'm suppose to connect the negative unlock wire from the alarm to, to fix my problem, thanks for all the help i will check out all the wiring again,

-------------
Du Truong


Print Page | Close Window