Print Page | Close Window

Dodge 3500 2001 Alarm/Remote Start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=6284
Printed Date: April 28, 2024 at 8:40 AM


Topic: Dodge 3500 2001 Alarm/Remote Start

Posted By: Irvin
Subject: Dodge 3500 2001 Alarm/Remote Start
Date Posted: December 05, 2002 at 3:08 PM

Factory Alarm & Disarm wire are the same on this truck...Arm is neg thru 644 ohm resistor, Disarm thru 1.5K resistor...Question is will I have to tap into to this wire in two different places (Arm & Disarm) with each wire having the designated resistor value in place, then connect each wire into two separate relays?

Is this the correct wiring of the two relays?

 Pin 87 arm or disarm thru resistor....  Pin 85 Neg from Arm & Disarm.. Pin 86 12V....Pin 30 Ground...  

Thank you...

Irvin



-------------
Irvin J Cruz
MECP Certified Installer



Replies:

Posted By: Derek
Date Posted: December 05, 2002 at 6:28 PM

Irvin,

You need to use 2 relays. 1 for the lock output and 1 for the unlock output. Your wiring will work on each relay.  posted_image



-------------


Print Page | Close Window