Print Page | Close Window

2004 Chrysler Concorde wiring chart

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=63515
Printed Date: March 28, 2024 at 10:06 AM


Topic: 2004 Chrysler Concorde wiring chart

Posted By: jimjimmerson
Subject: 2004 Chrysler Concorde wiring chart
Date Posted: September 29, 2005 at 10:08 PM

Hi guys, I've got a 2004 Chrylser Concorde coming in Saturday for a remote start install, does anyone have access to a wiring chart?  Thanks!!

-------------
Soylent Green is People



Replies:

Posted By: thepencil
Date Posted: September 29, 2005 at 10:28 PM


DIRECTWIRE™ WIRING INFORMATION - CHRYSLER / CONCORDE / 2004 / Remote Start


12volts red (40A), pink/black (40A)   +   ignition harness
Starter yellow   +   ignition harness
Second Starter N/A       
Ignition dk. blue/white   +   ignition harness
Second Ignition dk. GREEN/ red   +   ignition harness
Third Ignition N/A       
Accessory BLACK/ orange   +   ignition harness
Second Accessory BLACK/ white   +   ignition harness
Keysense lt. blue   -   ign harn or BCM, black plug, pin 24
Notes: The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.
Power Lock WHITE/ dk. green   +   BCM, blue plug, pin 5
Notes: Lock is positive trigger thru a 2.7K ohm resistor. Unlock is positive trigger thru a 620 ohm resistor. MUST use relays.

The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.

Can also use Directed 457C or 456L interface modules.
Power Unlock same as power lock wire       
Lock Motor orange   5wi back of junc block, brn plug, pin 3
Unlock Motor dk. blue   5wi back of junc block, brn plug, pin 7
Parking Lights+ BLACK / YELLOW   +   back of junc block, gry plug, pin 11
Parking Lights- yellow   -   switch or BCM, black plug, pin 2
Notes: Parking lights are negative trigger thru a 47 ohm resistor. MUST use a relay.

The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.
Hazards same as turn signal wires       
Turn Signal(L) lt. green   +   back of junc block, brn plug, pin 11
Turn Signal(R) tan   +   back of junc block, brn plug, pin 10
Reverse Light PURPLE / black   +   back of junc block, brn plug, pin 12
Door Trigger see notes   -   BCM, blue plug
Notes: The LF door is tan in pin 4, RF door is tan/red in pin 2, LR door is tan/red in pin 1, and RR door is tan/red in pin 10. Use all four wires and diode isolate each.

The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.
Dome Supervision yellow   -   front of junc block, tan plug, pin 4
Trunk/Hatch Pin tan/black   -   driver kick, harness to rear
Hood Pin N/A       
Trunk/Hatch Release BLACK/ white   +   switch or BCM, gray plug, pin 1
Notes: The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.
Power Sliding Door N/A       
Factory Alarm Arm lt. GREEN/ orange   +   BCM, blue plug, pin 13
Notes: Arm is positive trigger thru a 1.87K ohm resistor. Disarm is positive trigger thru a 680 ohm resistor. MUST use relays.

The BCM is attached to the back of the junction block, at the driver side end of the dash. The plugs for the BCM face the firewall.

Can also use Directed 457C or 456L interface modules.
Factory Alarm Disarm same as factory alarm arm wire       
Disarm No Unlock see factory alarm disarm       
Tachometer NOT dk. GREEN/ lt. green   ac   any ignition coil or fuel injector
Wait to start N/A       
Brake Wire WHITE/ tan   +   brake pedal switch
Parking Brake gray/black   -   back of junc block, tan plug, pin 1
Horn Trigger BLACK/ red   -   back of junc block, gry plug, pin 6
Memory Seat 1 pink/red   -   switch or memory mod under dr seat
Memory Seat 2 pink/white   -   switch or memory mod under dr seat
Memory Seat 3 N/A   -     
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Sentry Key
Part #: 555CW
Alternate Part1 #: 556UW
Alternate Part2 #: 555U
Alternate Part3 #: DesignTech 20402
Alternate Part4 #: DesignTech 29402
Notes: Only vehicles with gray keys have the immobilizer.
Interface Module: Category:
Door Lock Interface Required:
Yes Type:
Data Bus
Part #: 457CW
Alternate Part1 #: 456LW
Notes:



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image





Print Page | Close Window