viper 791xv?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=63621
Printed Date: July 14, 2025 at 2:17 PM
Topic: viper 791xv?
Posted By: robert p
Subject: viper 791xv?
Date Posted: October 01, 2005 at 11:00 PM
i just installed this on my 05 dodge ram. the problem is that on the keypad when disarming the alarm sets error chirps every time. i have the error chirp feature for arming disabled useing my bitwriter. the error that it say is that the drivers door was open please help. thanks ps sorry the post is not to easy to understand.
Replies:
Posted By: robert p
Date Posted: October 01, 2005 at 11:22 PM
i think it is due to the fact that the dome light stays on after the door is closed and the alarm is hooked up to the dome light not the door trigger. is there any way around this?
Posted By: cntrylvr79
Date Posted: October 01, 2005 at 11:24 PM
Sounds like you might have picked up a door trigger that reads off a delayed dome light. Check to make sure that you get a reading with the doors open and as soon as you close the door the wire reads nothing. Hope this helps.
-------------
Cause I'm So white and nerdy...
First Class Certi-fried installer
Posted By: robert p
Date Posted: October 02, 2005 at 9:33 PM
also ive installed door actuators and tehy seem to not have enough power to lock and unlock the doors on this truck ive had them work on many other cars but for some reason they will not lock and unlock every time. im thinking about running some relays to add power to the actuators. are there any other solutions???? thanks robert
Posted By: redpeppers
Date Posted: October 02, 2005 at 10:00 PM
u MUST ALWAYS us relays when adding actuators aftermarket......how did u have them hooked up before? if u hooked them straight to the alarm brain, u are lucky that it worked....also, ur error message, what zone is it saying that it is triggering?
-------------
Where theres is a wire there's a way.
Posted By: robert p
Date Posted: October 03, 2005 at 5:03 PM
ok got thge actuators to work great with the relay suplyed with the alarm it was my owm fault for not useing the relay the first time. as for the error code i believe its comming from the actuators trigering the shock sensor when locking. but what its saying on the alarm is that the shock sensor has been detected.
Posted By: redpeppers
Date Posted: October 03, 2005 at 5:17 PM
it is either the door shutting causing the shock sensor....u can turn the shock sensor down if u want......
-------------
Where theres is a wire there's a way.
Posted By: robert p
Date Posted: October 03, 2005 at 5:43 PM
i would like to keep the sensitivity up if i can but in about a week or 2 i will be installing a proximity sensor so at that point i think i can turn the shock sensor down and see if that is my problem. thanks
Posted By: redpeppers
Date Posted: October 03, 2005 at 11:51 PM
i dont really depeand on the shock sensor as a security....cause if goes off falsly when loud exhast or thunder is around ------------- Where theres is a wire there's a way.
|