installing a 508t & 530t

hello everyone . i'm going to install  a 508t with 530t on my viper 791xv i was wondering if anyone could help with a few questions.

1. the green and blue wires from the 508t just connects to the green wire from the stinger shock sensor right?

2. can i tap the power and ground wires from the shock sensor also or do i have to make seperate connections for those(not much of a problem but it would save a little time)

3.my shock sensor seems to be working ok but i'm not sure if its hooked up right, the shock sensor wires has a green wire loop on one end and a loose green wire on the other end. which was supposed to be plugged into the sensor and which end was supposed to plugg into the brain. just want to make sure i have it right before i connect my 508t to it.

4.after  i install the 530t will the 508t false alarm? and if so should i use a 610t replay to bypass the sensor and how do i wire it up?  need diagram.

i installed the 791xv alarm myself so i understand the basics but could not figure out this and searched may hours

thank you guys for any and all help

DO NOT USE the power and ground from the shock sensor....the green and blue wire from the the proxi goes to the blue wire on the shock sensor....i just tap off the green wire .....u wont need it

yes its a loose green wire. so i'm guessing on the shock sensor harness wire the side with the greeen wire looping is plugged into the shock sensor it self. so how do I bypass my proximity sensor so when i use the 530t window module it will not trigger the alarm?

thanks for the help

does anyone know if the 508t motion sensor will trigger when the 530t power window module is being used and if so. how do i use a relay to bypass the motion sensor?

any help is apreciated

thanks in advance

thanks a lot cntrylvr79 just a few more questions.for 30 and 86 doe the 12 volt need to be constant or switched? when you say go the the red wire on the sensor you mean it just needs to be tapped?

thanks again for all your help

demonpossessedn wrote:

---

thanks a lot cntrylvr79 just a few more questions.for 30 and 86 doe the 12 volt need to be constant or switched? when you say go the the red wire on the sensor you mean it just needs to be tapped?

thanks again for all your help

---

The 12volts must be constant.  As far as the red wire from the motion sensor goes, it just goes to 87a.  I Don't quite understand what you're asking me about it.