programming Autopage RS855
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=64529
Printed Date: May 15, 2024 at 10:40 PM
Topic: programming Autopage RS855
Posted By: phayzeone
Subject: programming Autopage RS855
Date Posted: October 17, 2005 at 1:04 PM
I just my Autopage RS855 installed in my 98 Acura Integra. I'm trying to program it so that it automatically locks when I turn the ignition on.
I followed the directions about turning the ignition on/off 3 times and leaving it in the off position. I push the valet button 5 times (holding in the 5th) but the only thing that happens when I hold it in on the 5th push is a page to my LCD pager. Anyone know what I could be doing wrong?
Replies:
Posted By: ualpow
Date Posted: October 17, 2005 at 4:20 PM
Do the other programing modes work for you? Also (please don't think I'm being a smart !#$ here) It is an 855 and not a 850 correct? The 850 is 4 pushes for that mode.
Posted By: phayzeone
Date Posted: October 17, 2005 at 6:23 PM
Yeah I have the 855
Posted By: ualpow
Date Posted: October 17, 2005 at 9:26 PM
phayzeone wrote:
Yeah I have the 855
Sorry, I figured you knew which unit you had. If you can get into all of the other programming modes then I would have to think bad unit. I assume that the alarm and remote start function properly. You can try resetting module to default settings and reprogram the options again.
Posted By: phayzeone
Date Posted: October 17, 2005 at 9:32 PM
I tried that. I can't get passed getting it into any programming mode.
Posted By: phayzeone
Date Posted: October 18, 2005 at 5:36 PM
The installer said he used my old valet button from my
old alarm (Push type button). In the manual it says
valet switch? Could that be causing the problem?
Posted By: ualpow
Date Posted: October 18, 2005 at 10:26 PM
phayzeone wrote:
The installer said he used my old valet button from my
old alarm (Push type button). In the manual it says
valet switch? Could that be causing the problem?
The valet switch in the autopage kit is a push button type also. Was your installer able to get into programming modes? Make sure your going all the way to ignition then off 3 times, not just to acc. Not sure how your cars' ignition is set up.
Posted By: phayzeone
Date Posted: October 18, 2005 at 10:53 PM
No. He just installed it and left it in default.
Posted By: phayzeone
Date Posted: October 18, 2005 at 11:00 PM
Should I actually start the car then turn it off?
Posted By: ualpow
Date Posted: October 19, 2005 at 3:54 PM
No don't go all the way to start. The default setting is with ignition controlled lock and unlock. Sounds like a wire came loose, bad ground or bad brain. Also the default for the remote start is Tach so your installer must have either learned the tach signal or changed it to voltage or timer check . Both would require entering programming modes.
Posted By: phayzeone
Date Posted: October 19, 2005 at 9:20 PM
I finally figured it out. The yellow ignition wire came loose from the fuse box. thanks!
|