Print Page | Close Window

Viper 591XV Turn Signal

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=64584
Printed Date: May 14, 2024 at 2:38 PM


Topic: Viper 591XV Turn Signal

Posted By: lexelite
Subject: Viper 591XV Turn Signal
Date Posted: October 18, 2005 at 8:10 AM

Wanted to know if there is anyway to Flash the Turn Signals (2 Channels, Pos) on the Viper 591XV w/o the use of relays?

Confirmation Flash for lock/unlock

In case you want to know, its for LED mirrors :)



Replies:

Posted By: mrcllusb
Date Posted: October 18, 2005 at 9:09 AM
You should be able to take the wire that normally go to the parking light circuit,and tap into the relay that controls ur 4 way flashers..

-------------
"ole blake"




Posted By: ringojam
Date Posted: October 18, 2005 at 3:55 PM
Use 2 diodes from park light and pick up at the hazzard switch.Meaning split the park light with 2 diodes and run one to the left turn and the other to the right turn signal wires at the hazzard switch




Posted By: lexelite
Date Posted: October 18, 2005 at 4:46 PM
The car only has one relay for both Turn Signals and Hazard Flashers. Not sure how to affect one without the other there.

Is is possible to tap the Hazard Switch instead?




Posted By: lexelite
Date Posted: October 18, 2005 at 4:52 PM
Do you have a diagram for the Toyota Hazard Switch?

If I read you correctly, you split the wire into a Y- Config then apply a diode after the switch on both sodes.

Right?




Posted By: lexelite
Date Posted: October 18, 2005 at 5:38 PM
Figured out the wiring, but activation on both sides are +

Does the 591XV pulse a Pos or Neg confirmation signal? If neg, should I use a relay to convert.

posted_image





Print Page | Close Window