Factory Remote Not Work w/RS
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=64627
Printed Date: May 16, 2025 at 3:49 PM
Topic: Factory Remote Not Work w/RS
Posted By: laa1212
Subject: Factory Remote Not Work w/RS
Date Posted: October 18, 2005 at 11:17 PM
Hi Guys, I installed a Crimestopper RS900 Remote Starter on my 2004 Toyota Sienna XLS Limited. If I remote start the van, the factory remote is not functioning. I can use the remote of the starter to lock/unlock driver and passenger door. Since this remote starter is the el cheapo type, there is no other output that I can program to open the to sliding doors and the hatch. So I resort to use the factory remote if possible. Since the RS900 can act as a "add on" to an existing or a factory alarm, I try that wiring. I was able to start the van by pressing the lock button on the factory remote. As soon as the van started via the remote starter, the factory remote again inoperable. Any ideas? Thanks, Andrew
Replies:
Posted By: redpeppers
Date Posted: October 18, 2005 at 11:29 PM
make sure u powered all the accessory wires.......what r all the wires u powered during remote start? let me know and i can help some more. ------------- Where theres is a wire there's a way.
Posted By: auex
Date Posted: October 18, 2005 at 11:37 PM
OK, first try this. Go put the key in the car and start it. Then with the engine running try to use the factory remote. Chances are it won't work.
If this is the case then the only thing you can do is deal with it or get a different alarm with outputs you can use.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: redpeppers
Date Posted: October 18, 2005 at 11:41 PM
ya that is what i would do ......swap all the features that r on ur factory remote over to the aftermarket remote......
-------------
Where theres is a wire there's a way.
Posted By: laa1212
Date Posted: October 19, 2005 at 12:31 AM
I power the Starter(thick black-yellow), Ignition1(black), Iginition2(thin black-yellow) , and Accessory(pink) wires at the ignition switch. I already know that once the van start with a the key, the factory remote won't work. I know that going with a different alarm with the outputs that I can use is the alternative, BUT I really hoping that there might be a solution that someone may know. There must a wire that tells the wireless/keyless module that the engine is running.
Posted By: Chris Luongo
Date Posted: October 19, 2005 at 1:33 AM
I tried interrupting ignition wires at the BCM/fusebox on a Sienna once-----I could finally get the factory keyless to work with the engine running, but then the climate controls wouldn't work----obviously that is no good.
As others here have said, the only real solution is to get the right product with enough outputs to control the sliding doors and hatch.
By the way, if you just pull on the handle for the sliding door, it will still slide open by itself----you might be able to live with that.
|