Highlander 2001 window diagram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=64788
Printed Date: July 19, 2025 at 3:12 AM

Topic: Highlander 2001 window diagram

Posted By: montuno
Subject: Highlander 2001 window diagram
Date Posted: October 21, 2005 at 4:02 PM

Hi...just need the colors for each window on the main switch.Thanks

Replies:

Posted By: mo12v
Date Posted: October 21, 2005 at 4:11 PM

Window Up	Driver\ RED Pass\ RED Dr.Rear\ RED PasRear\ RED @EACH SWITCH
Window Down	Dr.F/ GRN/RED Pas.F/ GREEN Dr.Rear/ GREEN Pas.Rear/ GREEN *

Reversal Rest At Ground Power Window Circuit
* This Vehicle Uses A Data Link Circuit For Power Windows. Wire Colors Given Are At Each Motor In Each Door.

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.

Posted By: montuno
Date Posted: October 21, 2005 at 4:24 PM

wow ...do I have to get them at each door ? Is not posible to get them at the drives main switch ? all I need is the colors for the driver switch.Or is it somewhere easier were they all meat at one place ? Thanks for the fast reply

Posted By: Chris Luongo
Date Posted: October 21, 2005 at 4:29 PM

I haven't done windows myself on a Highlander.

But what they mean by datalink is basically this: There are no window motor wires running throughout the car. Each power window switch also serves as a computer of sorts.

If you sit in the driver's seat, and push the button to roll one of the back windows down........ all that is happening is that your switch, through a data wire, commands the other door to roll its window down......so you're not going to find motor wires inside the car.

Posted By: montuno
Date Posted: October 21, 2005 at 4:40 PM

So what your saying is that it will not work if I connect the window roll module to the cables on the main switch ? I wiil have to make extensions for each cable to get to each motor ? That sucks

Posted By: montuno
Date Posted: October 30, 2005 at 2:27 AM

Still a little confused.There are 2 wires that go into each motor,in this case one to the up wire(red)to each motor no problem there and the other to the switch of the window on the door,thats where I qet stuck...what wire on the switch ? There are several wires at each switch.Here is the module diagram if it helps.This is for the 4 window up function.
posted_image