Print Page | Close Window

Installing AutoPage 855 in 05 Dodge Ram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=64833
Printed Date: July 25, 2025 at 8:17 PM


Topic: Installing AutoPage 855 in 05 Dodge Ram

Posted By: carnut510
Subject: Installing AutoPage 855 in 05 Dodge Ram
Date Posted: October 22, 2005 at 4:14 PM

I downloaded the wiring diagram for my truck and I have the diagram from my alarm. I have always installed my own alarms but this one is intimidating... I need some help guys... The Direct wiring diagram says to lock I need a 820 ohm negative, and to unlock I need a 330 ohm negative load, How do I do this? It also says I must use relays? The door trigger is done with each door having a individual wire... I followed the 1076 direct diagram it recommends, Where do i get these diodes and where do i put them?? Any other info would help... Thanks!




Replies:

Posted By: KarTuneMan
Date Posted: October 23, 2005 at 2:40 PM

As far as the diode isolation......all the diode lines (cathode) end, need to face the door FROM the BCM.

Relays as follows youll need 2, one for lock, one for unlock.. Pins 86 get constant fused 12v. pins 85 get triggered from your alarm. pins 87 get grounded.

pins 30 go to the one lock/unlock wire on the truck THRU the resistors. remeber pins 30 will have the resistors in line...then hook them to the purplr/green in the truck.  

Good Luck, let me know if you need any other help!



-------------



Posted By: flipper56
Date Posted: October 25, 2005 at 3:05 PM

KarTuneMan 

05 RAM Quad 1500 I got a guide from someone and it says lt. green for Lock motor and tan/lt. green for Unlock motor and should be 5wi connected could you explain 5wi

Thanks in advance

flipper56


Print Page | Close Window