Valet 561R install
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=64876
Printed Date: July 05, 2025 at 2:57 AM
Topic: Valet 561R install
Posted By: jaurora
Subject: Valet 561R install
Date Posted: October 23, 2005 at 11:10 AM
I am kind of new to the DEI product so your help is greatly appeaciated.
What wire on this unit is a (-) ground while running? I need to hook up a TB-TOYDL which requires this signal from the remote starter. Also I am hooking up the 555U as well. I know that the Red is +12 and the blue is status. What wire on this RS can be used for this? All this stuff is going into a 05 toyota highlander. Thanks in advance. My guess is that the 555U goes to the pink (-) third ign turn on and the ground while running goes to the blue stsus output wire. These wires are from the 4-pin satellite harness diagram
-------------
MECP certified (If it really means anything)
Jeremy
Replies:
Posted By: KarTuneMan
Date Posted: October 23, 2005 at 3:31 PM
Dont ya just HATE DEI....the blue "status" wire is your GWR.....
-------------
Posted By: kgerry
Date Posted: October 24, 2005 at 9:58 AM
actually its quite simple... any DEI installer can tell you status=GWR heck, a trained chimp could write it on a blackboard....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: jaurora
Date Posted: October 28, 2005 at 9:13 AM
Is this the only GWR wire on this unit. As I need to hook up the 555U, the TB-TOYDL, and an additonal relay for the second start wire. Thanks in advance ------------- MECP certified (If it really means anything)
Jeremy
Posted By: kgerry
Date Posted: October 28, 2005 at 9:18 AM
blue / white in the same plug as your brake wire is a 2nd status output
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: jaurora
Date Posted: October 28, 2005 at 9:19 AM
Thanks for the info. That was fast!!
-------------
MECP certified (If it really means anything)
Jeremy
Posted By: gus1
Date Posted: October 28, 2005 at 1:20 PM
The second status/ blue/white isn't too reliable as a GWR. I usually grab the pink in the wee 4 pin -ve out harness if I need additional GWR that is isolated from the main GWR (blue in the same plug). You needed a second start as well, so you are also using the purple in the same plug.
Gus
-------------
Wherever I go, that is where I end up......
|