94 Mazda b4000 cluthch bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65088
Printed Date: May 05, 2025 at 12:58 AM

Topic: 94 Mazda b4000 cluthch bypass

Posted By: hyperlite137
Subject: 94 Mazda b4000 cluthch bypass
Date Posted: October 26, 2005 at 10:23 PM

Hi I installed a remote start in a 94 mazda b4000, every thing works great except I can not figure out the clutch bypass. The truck does have cruise so there are 6 wires coming off of the switch. I have found the wire that is 12V when the ignition is in the position and the wire that receives 12V when ignition is at run and when the clutch is pressed down. Any info would help.

Thanks

Replies:

Posted By: infinkc
Date Posted: October 26, 2005 at 11:15 PM

at the clutch switch itself, find the wire that goes either 12v or ground when it is pressed, whatever wire gives you the different condition, that is the wire you want to tap into. if if goes 12v when pressed, have the alarm send a 12v signal to that wire via relay, if neg, have it send a neg signal. easy as that

Print Page | Close Window