Print Page | Close Window

Code-Alarm Programming

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65327
Printed Date: September 14, 2025 at 11:18 AM


Topic: Code-Alarm Programming

Posted By: brianloring1
Subject: Code-Alarm Programming
Date Posted: October 30, 2005 at 8:26 PM

Hi... I'm in the process of installing a code alarm ca-145 alarm which uses the ca-425a installation module. I have hooked up power, ground, ignition, siren, led/valet button, and door trigger wires. Today I wanted to test out the alarm and program a remote. I tried doing the normal programming sequence, but instead of chirping three times, it will only chirp four or five. This means that I can't get it in to programming mode. I might be doing something wrong, but I'm following the directions and everything seems ok except this problem. Please help me get it into programming mode! I'm puzzled.

Thanks so much

Brian




Replies:

Posted By: Chris Luongo
Date Posted: October 31, 2005 at 8:41 PM
What kind of car? Are you using the negative or positive door trigger wire?


Print Page | Close Window