Print Page | Close Window

1998 Blazer Remote Starter Install

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65352
Printed Date: July 23, 2025 at 3:17 AM


Topic: 1998 Blazer Remote Starter Install

Posted By: ginclined
Subject: 1998 Blazer Remote Starter Install
Date Posted: October 31, 2005 at 9:30 AM

Good Morning,

I'm doing a remote starter install on a 1998 Blazer and have been reading to make sure I have everything covered off.  One question is, how many of the ignition wires do i hook up?  I've read that in a lot of cases you have to 'power' the second wire.  By powering do you just hook up to the remote starter along with the first wire?  For this year and make how many Ignition wires do I have to power?

Thanks,
Bob.




Replies:

Posted By: Velocity Motors
Date Posted: October 31, 2005 at 10:28 AM
The Blazer has a 2nd IGN wire ( WHITE ) that required to be powered during remote start otherwise you will run into transmission failure in the near future. Depending on your system that you have you may or may not need a relay to power up the 2nd IGN wire. If your system has a designated (+) 2nd IGN wire, then just hook up the WHITE wire to this 2nd IGN output of the RS harness.
If your RS doesn't have the 2nd IGN (+) output and only a low level (-) output, then you will need to wire in a relay like this:

https://www.velocitymotorsport.com/images/install_notes/N2P.jpg



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA


Print Page | Close Window