93 4runner alarm install question
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65449
Printed Date: July 07, 2025 at 4:54 PM
Topic: 93 4runner alarm install question
Posted By: dbiggs
Subject: 93 4runner alarm install question
Date Posted: November 01, 2005 at 10:36 PM
I am installing an autopage rf-410 into a 93 toyota 4runner with manual trassmision. I am wanting to use the 3rd channel on a timed output to roll up the rear window. I know that the 3rd channel output gives a negitive pulse. I just need to know how to hook it up properly. I am an avid car stereo enthusist and have done quite a few installs but nothing as far as alarm install. also any tips or tricks would be apreciated. ie, type of door locks, starter kill hookup, ect..
Replies:
Posted By: Hornshockey
Date Posted: November 02, 2005 at 1:33 AM
you will most likely need a power window control module; they have preset resistor values that prevent damage to the window motors by shutting them down automatically when it reaches its fully up position. They use a negative output from the alarm for activation, so it should work for you. Power windows are generally a reverse polarity setup; so you can't just tap into the wire; a control module would be the way to go.
------------- Life moves pretty fast; if you don't stop and look around once in a while; you could miss it.
Posted By: dbiggs
Date Posted: November 02, 2005 at 1:52 AM
thanx I was hopeing this would not be the case. about how much do these run? an ac-69 for example. also what type of door locks does my 4runner have. 3 wire, 5 wire, ect.??
Posted By: dbiggs
Date Posted: November 02, 2005 at 1:57 AM
sorry that would be an ac-68 module
|