Print Page | Close Window

Glass break sensor bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65625
Printed Date: March 28, 2024 at 6:08 AM


Topic: Glass break sensor bypass

Posted By: Agdodge4x4
Subject: Glass break sensor bypass
Date Posted: November 04, 2005 at 6:05 PM

How do you bypass the glass break sensor when arming?

I am getting a 'bypass notification' chirp when arming my truck, and the zone that is flashing on the led is zone 4, which is the glass sensor. Don't know why. I turned off the bypass notification, but thats only for the zone 3.



Replies:

Posted By: pss5075104
Date Posted: November 04, 2005 at 8:26 PM
What kind of an alarm is it, and is it soldered into other sensor wires?

-------------
D

MECP First Class Certified Installer.

Nothing is impossable, it's just more expensive.




Posted By: Agdodge4x4
Date Posted: November 04, 2005 at 10:03 PM
It is a Matrix 10.5X. The glass break sensor is not soldered to anything, it is a direct plug in. Its got its own zone (zone 4). If the directions are correct, then the glass break sensor should NOT be active until 3 seconds after you arm it, so there is no way it can be picking up some noise somewhere. It does this whether you arm it in silent mode or normal. The other sensors are direct plug in play too, nothing special on this alarm.





Print Page | Close Window