Compu Star Alarm 2wamr

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65637
Printed Date: May 09, 2025 at 11:28 PM

Topic: Compu Star Alarm 2wamr

Posted By: bajoe
Subject: Compu Star Alarm 2wamr
Date Posted: November 04, 2005 at 11:12 PM

In Sept. '05 I had a Compu Star Alarm (2wamr) installed on my 2000 Oldsmoblie Intrigue. I have taken it back to the installer four times already for false alarms; shock problems and no sound when alarmed etc. My current problem is a false alarm occuring twenty minutes after arming the system and shows as an "open" trunk on the lcd display. After resetting there would be no further alarms until the system is rearmed again.

Can some one help by either telling me how to correct the problem or recommend an installer who can make this thing work.

Thanks

Replies:

Posted By: 05gt
Date Posted: November 04, 2005 at 11:34 PM

on that car you have to diode isolate the doorpin wires and the trunk pin wire, to prevent falsing

the colours are

DOOR TRIGGER

BLUE (-) and BLUE/WHITE (-)Use both, See NOTE *2

@ BCM, See NOTE *1

the you also have to diode the trunk pin wire, follow this diagram

https://64.85.6.129/extrainfo/diagrams/243_INTRIGUE_(-)%20NEGATIVE%20DOOR%20PIN%20ISOLATION%20CIRCUIT.pdf

Posted By: 05gt
Date Posted: November 05, 2005 at 8:46 PM

try this

https://64.85.6.129/extrainfo/diagrams/243_INTRIGUE_(-)%20NEGATIVE%20DOOR%20PIN%20ISOLATION%20CIRCUIT.pdf

Posted By: 05gt
Date Posted: November 05, 2005 at 8:48 PM

that doesn't work either

basically you will take two diodes twist on end together, the end with the two prongs on them goes to each door trigger wire, the other end with the single prong on it goes to the negative doore trigger output from the alarm

Print Page | Close Window