Wire Info Request - Nissan Pulsar GTI-R

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65643
Printed Date: June 20, 2025 at 12:31 AM

Topic: Wire Info Request - Nissan Pulsar GTI-R

Posted By: rhinopower
Subject: Wire Info Request - Nissan Pulsar GTI-R
Date Posted: November 05, 2005 at 9:51 AM

Please, and diagram for wiring the relay for the central locking, using a concept 650, i belive it is a single wire setup

Replies:

Posted By: infinkc
Date Posted: November 05, 2005 at 10:08 AM

year?

Posted By: muppet
Date Posted: November 05, 2005 at 10:19 AM

door locking is single point, a two wire door motor is required

-------------
paul

Posted By: rhinopower
Date Posted: November 05, 2005 at 10:33 AM

1994, can you give me a bit more info about adding the motor etc?

Posted By: muppet
Date Posted: November 05, 2005 at 11:05 AM

does the car lock from both doors, if the answer is no then the motor needs to be connected to the locking rod in the drivers door and then the wires ran into the car and connected to the alarm via two five pin relays

-------------
paul

Posted By: rhinopower
Date Posted: November 06, 2005 at 2:36 AM

muppet, which wiring diag do i need then for controlling the motor to lock/unlock the doors?

Posted By: ringojam
Date Posted: November 06, 2005 at 6:14 PM

Heres how to solve the problem. Pulsars have a door lock module left side of steering column. Lock and unlock drivers door manualy and listen its easy to find.Take a test light and probe the wires at the module they are - pulse but it will only unlock and lock at the passenger door. Put a two wire acuator install it in the drivers assuming you can install it run the two wires to the door lock module,and when pulsing the locks find the ouput for the passenger doors lock and unlock + output and connect the acuator wires to them,this will work like factory systems so when you lock and unlock at the factory switch all doors willwork posted_image