’99 Explorer hood pin

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65722
Printed Date: May 02, 2024 at 3:50 PM

Topic: ’99 Explorer hood pin

Posted By: mrdakota
Subject: ’99 Explorer hood pin
Date Posted: November 06, 2005 at 5:14 PM

I found the hood pin wire(per wiring diagram) but could not see a hood switch device? [tan/ light green(-)]

No voltage on it / closed or open just a constant 100ohms either open or closed to chassis ground and it runs into the key switch?

I hate the tought of using the pin switch that comes with the Valet 562T.

Replies:

Posted By: jvivek
Date Posted: November 06, 2005 at 7:04 PM

I have a 2000 ford explorer and I dont even have a hood switch, if you happen to have a light in the hood, which I dont, it is a mercury controlled switch, I would rather use the hood pin.

Posted By: redpeppers
Date Posted: November 06, 2005 at 9:39 PM

it prolly doesnt have one unless u have a factory alarm system

-------------
Where theres is a wire there's a way.

Posted By: draasch
Date Posted: November 09, 2005 at 7:02 AM

add one from scratch....best way to go.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Print Page | Close Window