Starter cut/interupt circuit

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65893
Printed Date: May 09, 2024 at 5:05 PM

Topic: Starter cut/interupt circuit

Posted By: g-man604
Subject: Starter cut/interupt circuit
Date Posted: November 08, 2005 at 11:36 PM

Can i tap into this and add more relays to say cut ECU main power etc?

-------------
Its all Mind over matter... I dont mind so it dont matter

Replies:

Posted By: jshhhs
Date Posted: November 08, 2005 at 11:56 PM

Yeah BUT remember that whatever component you want to control will need its own relay so it can see the proper voltage when the alarm is not on. When you start the car or dis arm the alarm the ECM will see the juice so just make sure its the right voltage that it sees. Also if you are killing the ECM every time you arm the alarm its the same as unhooking the batt and you will have to reset any clocks etc in your car. Hope this helps.

-------------
What the feezy?

Posted By: tonyberg
Date Posted: November 09, 2005 at 12:05 AM

I would probably use something like fuel pump disable or something along those lines so you aren't makin the ecu relearn the car everytime....they store alot of info in terms of Long term fuel curves and such

Print Page | Close Window