2002 chevy envoy remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65915
Printed Date: April 27, 2024 at 3:50 AM
Topic: 2002 chevy envoy remote start
Posted By: elvis233
Subject: 2002 chevy envoy remote start
Date Posted: November 09, 2005 at 8:38 AM
just installed a disigntec remote starter in my 2002 chevy envoy but it's not working.. i think the problem is caused by the factory alarm system because the remote start is sending power to the starter wire when activated.. but the starter doesnt crank over,, the wire diagram i have says the alarm disable wire is located inside the drivers door at module,, but i can't find any module inside drivers door.. can somebody please help me !!
Replies:
Posted By: stang351w
Date Posted: November 09, 2005 at 8:44 AM
it wouldn't be hte factory alarm doing that..i beleive the factory alarm in those cut off the fuel pump. sounds to me like you don't have the starter wire from the unit onthe right starter wire in the vehicle. if i remember right it's the large yellow wire in the wire harness...when you go to remote start the vehicle does the heater come on or is it all dead?
-------------
Tri County KustomZ
certified installer
Posted By: elvis233
Date Posted: November 09, 2005 at 9:03 AM
i have it to the correct wire (yellow wire) i also checked it with a test lite and it lites up when in start postion only
Posted By: mo12v
Date Posted: November 09, 2005 at 9:30 AM
elvis233 wrote:
i have it to the correct wire (yellow wire) i also checked it with a test lite and it lites up when in start postion only
Would that be in the CRANK Position? With the Key? What ByPASS Unit are you using?? ------------- MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Posted By: elvis233
Date Posted: November 09, 2005 at 9:59 AM
yes.. crank position. sorry
not using a bypass.. what do i need to bypass
Posted By: gus1
Date Posted: November 09, 2005 at 10:54 AM
DEI part # 555L to bypass the passlock2 system in that vehicle.
Gus
-------------
Wherever I go, that is where I end up......
Posted By: kgerry
Date Posted: November 09, 2005 at 10:54 AM
555L or GMBP or 457G
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: davedyer79
Date Posted: November 09, 2005 at 4:12 PM
You actually need to bypass two seperate features in that vehicle. The doorlocks are "multi-plexing", meaning they talk back and forth to several computers for lock/unlock features. It is not the simple two wire +/- or reverse ground. The Envoy also has a Passlock interface, or factory anti-theft system. A good bypass like kgerry mentioned is the GMDL-BP, all in one bypass. This one bypass will do both. Very simple installation and fairly simple programming and you will be finished. Good luck. I get these from my dealer, should be able to get them off the net. Here is a link to one site, never ordered from them before so cant verify anything. https://www.audiooutfitter.com/store/GMDLBP.html ------------- davedyer79
Posted By: gus1
Date Posted: November 09, 2005 at 4:29 PM
Didn't say that he needed doorlock control......
Gus
-------------
Wherever I go, that is where I end up......
Posted By: elvis233
Date Posted: November 10, 2005 at 7:08 AM
just remote start.. no door locks
Posted By: davedyer79
Date Posted: November 10, 2005 at 8:57 AM
OH sorry, 03 and newer require doorlock module, my bad. Still need the passlock, of PL-DATA. SHould be able to pick one up quick and easy off Ebay.
-------------
davedyer79
|