theft bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=65955
Printed Date: July 13, 2025 at 1:41 PM

Topic: theft bypass

Posted By: greenst
Subject: theft bypass
Date Posted: November 09, 2005 at 8:12 PM

I have a 2001 Ford Explorer with a command start remote starter installed. For some reason when I go to remote start the car the theft light flashes and it doesn't turn over. I looked under the dash for a anti-theft bypass. I found the ring around the ignition followed that to a relay with a key attached, but I have yet to find the module. I took the key out and programed it with the original thinking that was the problem. So, now that the key is programmed I set it back up just like I found it, but it still won't start. When I put the key in the ignition and press the button it works so I am confused to if I still have the anti-theft bypass installed. If anyone can help me that would be much appreciated.

Replies:

Posted By: mo12v
Date Posted: November 09, 2005 at 8:53 PM

greenst wrote:

I found the ring around the ignition followed that to a relay with a key attached, but I have yet to find the module. .

Your off to a good Start.......
That is the OLD way or CHEAP way of installing a ByPASS...........
Make sure you have the wire wrapped around the Head of the Key at least 5 times. Make sure the Relay Powers Up during & after Cranking.........

Check:

https://www.wiringinstructions.com/239.htm

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.

Print Page | Close Window