05 Equinox
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=66082
Printed Date: July 21, 2025 at 9:19 PM
Topic: 05 Equinox
Posted By: Lmsc
Subject: 05 Equinox
Date Posted: November 11, 2005 at 7:51 PM
I installed a remote starter in this truck last weekend and the Passlock & wrench lights come on when started by remote. I have the keysense wire (-) hooked up and I have the passlock bypassed. The lights only come on when remotely started, works great if you cancel the remote and then start it with the key.
-------------
LMSC
Replies:
Posted By: chriswallace187
Date Posted: November 11, 2005 at 7:59 PM
Make sure you are powering both accessory wires as accessories and not ignitions. I did a Monte Carlo once with one of those two powered as ignition, and the passlock kind of went bonkers.
-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
Posted By: Velocity Motors
Date Posted: November 11, 2005 at 9:05 PM
What bypass did you use ? Some of the modules that use a set resistor value are not as good as some of the self learning modules.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: extreme1
Date Posted: November 11, 2005 at 10:56 PM
I like using the PLXR with that vehicle as it has the keysense output on it.
make sure you've diode isolated your keysense from your bypass (ground when running)
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: Lmsc
Date Posted: November 12, 2005 at 10:29 AM
Thanks guys for the info. I bought a new bypass and it works fine.
-------------
LMSC
|