Print Page | Close Window

92 celica alltrac compustar cm3000 cn2

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=66456
Printed Date: May 08, 2024 at 5:46 PM


Topic: 92 celica alltrac compustar cm3000 cn2

Posted By: involution
Subject: 92 celica alltrac compustar cm3000 cn2
Date Posted: November 17, 2005 at 2:33 PM

I've purchased a CM3000 brain, and am mapping out wiring before I begin. I'd like a little clarification on the second ignition wiring, which my car has.
Ref: 1990-93 celica


CN2-pin3 (-)2nd ignition 200mA output
So in order to get a (+) output to my vehicles's 2nd ignition wire, I need to solder this wire to the pigtail on CN1, and then use that relay's blue wire to hook up to my 2nd ignition wire (B/O on vehicle ignition harness).

This is my understanding, please let me know if I'm on the right track. If I'm way off base, please be gentle!



Replies:

Posted By: thepencil
Date Posted: November 17, 2005 at 3:12 PM
involution wrote:

I've purchased a CM3000 brain, and am mapping out wiring before I begin. I'd like a little clarification on the second ignition wiring, which my car has.
Ref: 1990-93 celica


CN2-pin3 (-)2nd ignition 200mA output
So in order to get a (+) output to my vehicles's 2nd ignition wire, I need to solder this wire to the pigtail on CN1, and then use that relay's blue wire to hook up to my 2nd ignition wire (B/O on vehicle ignition harness).

This is my understanding, please let me know if I'm on the right track. If I'm way off base, please be gentle!





Correct!

Below is a wiring diagram of your car. You may find it useful.


TOYOTA CELICA 1992

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |
|              12V|white or BLACK/ red |+ |ignition harness            |
|          STARTER|BLACK/ white        |+ |ignition harness            |
|        IGNITION|blue/red            |+ |ignition harness            |
| SECOND IGNITION|BLACK/ orange        |+ |ignition harness            |
|        ACCESSORY|gray               |+ |ignition harness            |
|       POWER LOCK|blue/black          |- |drivers kick panel          |
|     POWER UNLOCK|blue and green *2   |- |drivers kick panel          |
| PARKING LIGHTS +|dk. green           |   |drivers kick panel          |
| PARKING LIGHTS -|lt. green           |   |steering column             |
|       HEADLIGHTS|RED / yellow          |- |steering column             |
|     DOOR TRIGGER|RED / white           |- |fuse box                    |
| TRUNK/HATCH PIN|RED / white *3        |- |trunk light                 |
|       TACHOMETER|black or WHITE/ blue |   |check connector *1          |
|       BRAKE WIRE|GREEN / WHITE        |+ |drivers kick panel          |
|     HORN TRIGGER|green               |- |steering column             |
|           WIPERS|blue/orange        |+ |steering column             |
| LF WINDOW UP/DN|green - red        |A |drivers door switch        |
| RF WINDOW UP/DN|grn/wht - RED / blu   |A |drivers kick panel          |


Notes:
*1 The check connector is located just behind the drivers shock tower. *2 Use both wires and diode isolate each. *3 Tied in with door trigger on hatchback models.

-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image





Print Page | Close Window