key programming

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=66475
Printed Date: July 06, 2025 at 3:55 PM

Topic: key programming

Posted By: maxcat
Subject: key programming
Date Posted: November 17, 2005 at 7:53 PM

Hey guys, I am going to be programming a blank key for r/s in a 2001 DODGE DURANGO. Apparently there are 2 ign wires and 2 acc wires in this vehicle. During the programming seqence (power up the ignition) does anyone know if all four of these wires need to be powered up, or just the 2 ign wires. I thought I read somewhere that all 4 have to be powered up but don't know if this is true and can't remember where I read this. Any advice or help would be greatly appreciated.

Thank-you in advance

Replies:

Posted By: OhioMike1101
Date Posted: November 17, 2005 at 8:33 PM

what exactly are you asking? How to program the key or which wires in the IGN need hooked up?

Posted By: maxcat
Date Posted: November 17, 2005 at 8:54 PM

Sorry should have been more clear, no , i know how to program the key, but one of the steps to programming the key is to power up the vehicles ignition using a jumper. I did read somewhere that both ign and acc wires needed to be powered up during this programming step. Trying to verify if this is correct or if it is just the 2 ign wires that need to be powered. Thank you for the reply

Print Page | Close Window