2001 Windstar RS/KE

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=66576
Printed Date: July 22, 2025 at 6:57 PM

Topic: 2001 Windstar RS/KE

Posted By: Memphisman
Subject: 2001 Windstar RS/KE
Date Posted: November 19, 2005 at 7:05 AM

I will be installing A RS/KE in a 2001 Ford Windstar in a few days and I have all the wire colors except the ones that control the left and right power sliding doors. Does anybody know what color/location/polarity these are?

Replies:

Posted By: sparkie
Date Posted: November 19, 2005 at 1:36 PM

I believe the left sliding door wire is WHITE/ Green and the right one is GREEN/ Red. Both are a negative pulse and can be found at the switches.

-------------
sparky

Posted By: Memphisman
Date Posted: November 29, 2005 at 5:18 PM

I just installed a R/S in a 2001 Ford Windstar and everything works accept for the accessories (Heat/AC)because I can't find the Violet/Orange wire. It is suppose to be in the Ignition Switch Harness but it's not there. I did find one in another harness (about 18AWG) and it works like an acc wire, but when I hook it up-nothing. The R/S is sending +12V like it should. Any help would be greatly appreciated (It's been a bad week for starters working right).

Posted By: Mike M2
Date Posted: November 29, 2005 at 7:23 PM

Accessory in a Windstar is yellow and BLACK/ lt. green, 2 wires. Voilet/orange is year y2k and earlier....

-------------
Mike M2
Tech Manager
CS Dealer Services

Posted By: mo12v
Date Posted: November 29, 2005 at 7:48 PM

Power Sliding Doors: Left Power Sliding Door Open/Close is GRAY / YELLOW (-) Right Power Sliding Door Open/Close TAN/RED (-).Both Located At Rear Electonic Module Behind Rear Passenger Quarter Panel.

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.

Posted By: Memphisman
Date Posted: November 30, 2005 at 7:22 AM

Thanks for the help. I was able to use the wires at each switch for the power side doors.

Print Page | Close Window