command start programing

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=66779
Printed Date: May 13, 2025 at 10:00 PM

Topic: command start programing

Posted By: muaiad97
Subject: command start programing
Date Posted: November 21, 2005 at 8:48 PM

hi evryone

i have command start remot starter cs310i anyone has the programing instruction or user manual.

thanx

Replies:

Posted By: stang351w
Date Posted: November 21, 2005 at 9:04 PM

check out grandwestauto.com (beleive that's right) i got infor on a cs250i from there, unless it's really new then you might have luck finding automobility distribution a good place to go...there located in montreal

-------------
Tri County KustomZ
certified installer

Posted By: 05gt
Date Posted: November 21, 2005 at 9:05 PM

what programming do u have to do

Posted By: stang351w
Date Posted: November 21, 2005 at 9:07 PM

prob for the tach settings and single or double pulse door locks...little stuff like that.. i didn't mind programming the tach...but it wasn't as easy as the autostarts

-------------
Tri County KustomZ
certified installer

Posted By: muaiad97
Date Posted: November 21, 2005 at 9:20 PM

thanx guys

just user manual wiring istructions

Posted By: 05gt
Date Posted: November 21, 2005 at 9:20 PM

if you want to program tach

hold the hoodpin down for 4 seconds, let it up, then press down and then up, the parklights will stay on

go inside the vehicle and press the brake, while holding the brake down press the lock and unlock buttons on the remote and hold untill the lights flash 5 times release brake

start the vehicle with the key and let it reach proper idle, when this happens press and hold the brake once more, when tach has been detected the lights will once again flash 5 times

Print Page | Close Window