2005 chevy avalanche, audiovox AX901
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=67075
Printed Date: May 18, 2024 at 4:14 AM
Topic: 2005 chevy avalanche, audiovox AX901
Posted By: 05gt
Subject: 2005 chevy avalanche, audiovox AX901
Date Posted: November 26, 2005 at 6:30 PM
I am installing a audiovox AX901 into this vehicle, I haven't hooked the bypass up yet , I try to remote start with the key in the ignition and it starts but immediately dies also the air bag light has come on even when I start the vehicle with the key ignition 2 off of the alarm brain is hooked up to the white wire in the vehicle, which is ignition 2 someone please help cause customer will be here at 6 pacific time to pick vehicle up
Replies:
Posted By: mo12v
Date Posted: November 26, 2005 at 7:26 PM
You need to Power up all 3 Ignitions...
You should hook up your ByPass prior to Remote Start also | Constant 12 volts | RED & RED / WHITE | IGNITION SWITCH HARNESS | | Ignition 12 volts | PINK | IGNITION SWITCH HARNESS | | Starter | YELLOW | IGNITION SWITCH HARNESS | | Dome Light | GREY/BLACK (+) | AT BCM * | | Trunk Pin Switch | N/A | | | Parking Lamp | GREY/BLACK (-) | AT MAIN SWITCH | | Power Lock | GREY | IN EACH DOOR DUE TO #205 | | Power Unlock | TAN | MULTIPLEXING ** |
* BCM Located Below Steering Column ** Reversal Rest At Nothing Door Locks Click Here For Our Databus & Immobilizer Bypass Cross Reference
| Accessories | | Window Up | D\ BLUE P\ BLUE D\BLUE P\BLUE @ Each Switch Due To Data Link | | | Window Down | F/ BROWN F/ BROWN R/BROWN R/BROWN | | | Ign Key Warn | LIGHT GREEN (-) | IGNITION SWITCH HARNESS | | Trunk Release | N/A | | | OEM Horn | BLACK (-) | STEERING COLUMN HARNESS | | Headlights | WHITE (-) | AT HEAD LIGHT SWITCH | | OEM Alarm Arm | | | | OEM Alarm Disarm | LT GREEN (-) | IN PASS KICK PANEL |
Reversal Rest At Ground Type Window Circuit Wiring
OEM Hood Pin Wire Is PINK/BLACK @ Switch On Top Of Radiator Support | Remote Start | | Tach Signal | WHITE | AT PCM * | | Ignition #2 | WHITE | IGNITION SWITCH HARNESS | | Ignition #3 | ORANGE | IGNITION SWITCH HARNESS | | Accessory | BROWN | IGNITION SWITCH HARNESS | | Neutral Safety | WHITE (-) | PCM CONN C3 PIN #13 * | | Brake Light | WHITE (+) | AT SWITCH ABOVE BRAKE PEDAL | | Reverse Light | LIGHT GREEN (+) | EITHER TAIL LT ASSY OR TRAILER CONN** | | Rear Window Defrost | N/A | |
*PCM Located On The Drivers Side Of The Motor. Tach Wire Is In The BLUE Conn (C1) Closest To The Firewall,Pin #49. Also Found Back Of Cluster in 24 pin GREY Conn Pin # A12 ** Also Found At BCM In 6 Pin Black Connector
G.M. Passlock II Bypass ------------- MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Posted By: cntrylvr79
Date Posted: November 26, 2005 at 7:29 PM
You'll have to hook the bypass up before the truck will remote start. Just putting the key in the ignition will not do it the code is generated when the key is turned to the crank position. The airbag light should assuming nothing got cut or disconnected shut off about 7 seconds after the vehicle starts running. Good luck
-------------
Cause I'm So white and nerdy...
First Class Certi-fried installer
Posted By: 05gt
Date Posted: November 26, 2005 at 9:27 PM
mo12v, at the time when I posted this I had taken the bypass out to see if it was the issue, I did have it in prior and I tried remote starting but when no luck, then I took it out Didn't know it had 3 ignition wires, every possible website I checked (4 of them) said it had 2 ignition wires and 2 accessory wires, I even triple tested I am guessing that is why the airbag light is on, cause I didn't hook up ignition 3 just out of curiousity where did you get the info you posted earlier
Posted By: mo12v
Date Posted: November 26, 2005 at 9:59 PM
Personal DATA , & OMEGA......
The ORANGE wire is not Airbag
That is how i power up these wires..........
Make sure you have evrything ready & Installed prior to ByPass Programming
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Posted By: 05gt
Date Posted: November 26, 2005 at 10:07 PM
just want to make this clear, the vehicle has 3? ignition wires, and 1 accessory wire? so the third ignition wire in the vehicle is Orange, and has to be powered as third ignition? I didn't mention that when I go to remote start the vehicle it trys to start and it does, but right away it shuts itelf down this is how I had it pink (1st ignition) to pink in the vehicle, pink/white (2nd ignition) to white in the vehicle, orange (1st accessory) to orange in the vehicle, and I did have ORANGE / white (2nd accessory) to brown in the vehicle, when I had it like this it wouldn't do anything I cut the ORANGE / white wire from the brown and it was able to start but then immediately die, that is as far as I got
Posted By: anickle
Date Posted: November 27, 2005 at 1:13 AM
I have always had luck with the orange as an acc, where do you have the passlock module grounded to? passlock ground in the column has not always worked for me in newer gm's and chev's so i ground them right to the kick. good luck
-------------
andrew nickle
Posted By: 05gt
Date Posted: November 27, 2005 at 1:18 AM
the passlock ground is going to the black passlock wire up at the ignition switch what do u mean in the kick panel
Posted By: anickle
Date Posted: November 27, 2005 at 1:21 AM
sorry i mean i ground it to the body in the kick panel, or the fire wall if thats easier for you ------------- andrew nickle
Posted By: 05gt
Date Posted: November 27, 2005 at 1:26 AM
Well I will try something along those lines when I get the customers car back I always thought the black off of the module goes to the passlock ground from the ignition didn't know you could just ground it anywhere Do you have any info on the ignition wires and why maybe the airbag light is on
Posted By: anickle
Date Posted: November 27, 2005 at 1:31 AM
I always thought it was ground for passlock aswell but i ran inot i think it was an 03 chev halfton and good old Gus set me straight with that one. Sometimes they work, sometimes they don't. For the airbag light I couldn't tell you i have never seen it pop before, did you knicked the airbag shround surrounding the airbag wires and maybe cut one? Good luck when it comes back, let us know.
-------------
andrew nickle
Posted By: 05gt
Date Posted: November 27, 2005 at 1:35 AM
I didn't accidently cut or knick anything, cause where I was working I always saw where the air bag wire was, I wasn't really even working around that area, cause I got the ignition wires further down the coloumn near the BCM
Posted By: cloneman315
Date Posted: November 27, 2005 at 3:06 PM
u do not need to hook up brown wire for this 2 work ,only brown wire in trailblazers envoys cadilacs and higher end buicks
Posted By: 05gt
Date Posted: November 27, 2005 at 8:39 PM
cloneman315 wrote:
u do not need to hook up brown wire for this 2 work ,only brown wire in trailblazers envoys cadilacs and higher end buicks
but do I need to hook up orange in the behicle as ignition, or accessory
Posted By: anickle
Date Posted: November 27, 2005 at 9:02 PM
hook orange up as acc. If you notice when you start the truck the climate controls and stereo and that stuff will turnoff for a split second during crank. The orange wire runs the climate controls, so presumebly you would waqnt to hook acc up to that. Like cloneman said you do not need brown wire in this truck because it runs the radio.
-------------
andrew nickle
Posted By: 05gt
Date Posted: November 28, 2005 at 1:57 PM
alright so I do have all wires powered up correctly, does it matter if you get ignition 1 and 2 backwards for example: ignition 1 wire from the brain hooked to ignition 2 in vehicle and vice versa cause right now I have ignition 1 wired to the pink in the truck, and ignition 2 wired to white in the truck, and I have accessory off of the brain wired to orange in the vehicle I am leaning towards a bypass issue, I am using the 555L and when I remote start the truck it fires up and then instantly dies
Posted By: 05gt
Date Posted: November 28, 2005 at 6:01 PM
ttt
|