Compustar CM-3000-V2 starter problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=67231
Printed Date: May 11, 2025 at 5:00 AM

Topic: Compustar CM-3000-V2 starter problem

Posted By: Tinted
Subject: Compustar CM-3000-V2 starter problem
Date Posted: November 28, 2005 at 10:30 PM

ok its in a 97 huyndai elantra. half the time the starter just doesnt 'start'. the ignition comes on but nothing else happens. then other times it will start to crank but wont fire up the engine and other times it starts just fine.....

can anyone suggest where to look?

Replies:

Posted By: metaverse
Date Posted: November 28, 2005 at 11:16 PM

All of your wiring connections concerning the ignition and the starter circuit. Check the starter bypass relay as well.. Sounds like a poor connection issue..

Posted By: Velocity Motors
Date Posted: November 29, 2005 at 11:25 AM

If you used connectors then cut them all out and use solder and tape. If you used solder and tape, ensure that there's isn't a cold solder and then move onto the starter disable relay as suggested by metaverse.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: Tinted
Date Posted: November 30, 2005 at 12:39 AM

how about if the car starts when the engine is warm and wont start on the cold engine?

Print Page | Close Window