tach not programmed on Rem Start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=67689
Printed Date: May 31, 2024 at 10:11 PM

Topic: tach not programmed on Rem Start

Posted By: radioflyer
Subject: tach not programmed on Rem Start
Date Posted: December 05, 2005 at 10:14 AM

I have a prestiege (audiovox) alarm w/ remote start and the tach got unprogrammed after having the battery disconnected for some time. I tried the instruction manual's procedure for tach re-programming but it did not work. I think the sensor may have been accedentally pulled loose. where can i find this (and how to fix it) on a 1997 silverado pickup?
thanks

-------------
you can never have too much of a good thing

Replies:

Posted By: sparkie
Date Posted: December 05, 2005 at 5:50 PM

Audiovox usually uses a GREEN/ orange wire for their tach wire. You may have to trace where it goes to see if it is still connected. It may go to the back of the motor towards the ignition system or towards the engine computer on driver's side fender.

-------------
sparky

Print Page | Close Window