ungo remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=67736
Printed Date: May 02, 2024 at 7:29 AM
Topic: ungo remote start
Posted By: fatheadjames
Subject: ungo remote start
Date Posted: December 05, 2005 at 7:23 PM
I'm trying to find the installation manual for a saa4295 remote start piece. It is installed along witha ms8200 in the truck I just bought. It currently doesn't work and am wanting to reinstall it. Also if there are any programing directions for it. Thanks in advance.
Replies:
Posted By: tacalin
Date Posted: December 06, 2005 at 5:47 AM
with engine running press the button(s) for aux. function which engage the remote start. you must to hear the relays. remove the key from ignition and see if the engine still running. if you have a manual transmission must have the hand-brake engaged before pressing the button. the single programing feature for this model is engine run time. try this and if don't start I'll send you the wires.
Posted By: fatheadjames
Date Posted: December 06, 2005 at 12:08 PM
I tired that and nothing happened; so if you can send me that info it would be great. You can post it here or e-mail me. Thanks for the help.
fatheadjames@hotmail.com
Posted By: tacalin
Date Posted: December 07, 2005 at 3:26 AM
Main connector:
violet - ign out (+) -> violet (don't connect these two wires at the ign key. you will burn a transistor on remote start)
green - (+) led out -> red led wire
yellow - (-) start command -> aux. function yellow/....
WHITE/ brown - (-) starter disable in -> blue
BLACK/ white - (-) sensor defeat out -> gray/black
black - ground
PURPLE / white - (+) ign input -> connect with purple large wire
blue/black - (+) brake pedal input
GREEN/ purple - (+) wait to start input -> connect with blue large wire (for diesel engine connect to glow plug)
orange - (-) running light (don't use)
GREEN/ YELLOW - (-) hood switch
WHITE/ yellow - tach input
Large wires:
purple - IGN
blue - STARTER (to starter)
red - +12V
white - ACC
yellow - STARTER (to ign key)
2 pin connector (back):
WHITE/ orange - (-) hand brake (use just for manual transmission)
WHITE/ blue - not used
For run time programing: system off, engine off. open the hood and press the remote start activation button. press 1 time = 1 minute, press 2 times = 2 minutes.....(max. 256 minutes). for each press led will go on.
good luck! you will need.
Posted By: fatheadjames
Date Posted: December 08, 2005 at 10:23 PM
Thanks for the info man. I guess this thing is just fubar. Oh well guess I'll buy a new alarm.
|