Print Page | Close Window

1999 Cadillac Eldorado remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=67754
Printed Date: October 31, 2024 at 6:07 PM


Topic: 1999 Cadillac Eldorado remote start

Posted By: link123
Subject: 1999 Cadillac Eldorado remote start
Date Posted: December 05, 2005 at 9:37 PM

Hi,

I am planning to install a remote starter on this my vehicle, please tell me what bypass I need for this particular car.  Also direct me where I can purchase the module.

thx




Replies:

Posted By: mobileworks
Date Posted: December 05, 2005 at 10:22 PM

bypass



-------------




Posted By: secureauto
Date Posted: December 05, 2005 at 10:38 PM
Here's a link for your car:

99 Eldorado

And here's a link for VATS bypass diagram, no need for module:

techtip 1049

-------------
ASE Certified




Posted By: link123
Date Posted: December 07, 2005 at 12:04 AM

where can I buy the 652T resistor pack?   or can I use a 555U?





Posted By: secureauto
Date Posted: December 07, 2005 at 11:19 PM
There's no need to buy the whole pack, your Cadi's key should have a small black chip looking thing on it. That's a resistor, use a Digital Multi Meter, switch to resistance or Ohm's and measure the resistor on your key. Go to your nearest Radio Shack and pick up some resistor's. You may not find the exact value of resistor at the store, but if you find one very close in value, about 5% over or under the value should be o.k. adding resistor's in line (series or parallel) is ok to come close to the value on your key.

-------------
ASE Certified




Posted By: link123
Date Posted: December 29, 2005 at 8:54 AM

I check at radio shack and they have the 1/2w carbon film resistor and 1/4w carbon film resistor,  what watt should I get?





Posted By: robdog1969
Date Posted: December 29, 2005 at 1:46 PM
1/4 w is fine if you want to all you have to do is cut  the orange ribbon wire and solder a resistor on the 2 wires comming from firewall but it defeats the vats

-------------
over 20 years of experience in the 12 volt industry





Print Page | Close Window