Print Page | Close Window

arrow 3 and sensor probs

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=67777
Printed Date: July 13, 2025 at 5:18 AM


Topic: arrow 3 and sensor probs

Posted By: jinjur
Subject: arrow 3 and sensor probs
Date Posted: December 06, 2005 at 5:15 AM

Hello,

Ok....some of my problems gone....a couple remain.

On my arrow 3, when i plug a proximity sensor 3 into the single zone input and a duplex piezo sensor into the dual zone input, the light on the piezo sensor stays on.

Does anyone know why this is?

When i remove the proximity sensor the light goes out on the piezo sensor

HELP



-------------
jinjur @ belfast @ n.ireland



Replies:

Posted By: scirocco16v
Date Posted: December 06, 2005 at 11:11 PM

First check to see if the prox sensor is putting out constant ground with a meter it could be defective.  If it is not, put a diode in line with the shock sensor orange wire,  with the band facing the sensor.  By the way, I have done similar setups with that alarm and never had to diode, might be a bad sensor.




Posted By: jinjur
Date Posted: December 07, 2005 at 4:10 AM

Hi Scirocco,

Thanks for your reply......i havent checked anything with a meter yet but i just assumed it would all...well...y'know...work.

Will check that tonight.........i hope its not a busted sensor.....wont be happy

:(



-------------
jinjur @ belfast @ n.ireland


Print Page | Close Window