Ford PATS
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68144
Printed Date: May 12, 2025 at 4:39 AM
Topic: Ford PATS
Posted By: jweld97
Subject: Ford PATS
Date Posted: December 11, 2005 at 4:05 PM
When I probe the 4 wire connector coming from the PATS module, 2 show 11.5v or so only when the key is turned on as they should. But a third wire shows 1.7v or so with key off and 9.6v or so with key on and the fourth shows 0v at any time as it should being a data wire. So I am not sure what to do for hooking up my bypass module which is a xk04ford, the rs is a jkrs3 and it is going in a 2000 F150.
Replies:
Posted By: pimpedprobegt
Date Posted: December 11, 2005 at 7:44 PM
The 4 wires are power, ground, RX and TX. Power and ground are always next to eachother, Rx is usually grey w/orange, and TX is usually white w/light green. Find your power with key on, the on next to it should be ground. Then hook up your other two wires to RX and TX, if you have it the wrong way, the vehicle will not start with the key, if it starts they are the right way.
Posted By: ruse
Date Posted: December 29, 2005 at 11:12 PM
jweld97 wrote:
When I probe the 4 wire connector coming from the PATS module, 2 show 11.5v or so only when the key is turned on as they should. But a third wire shows 1.7v or so with key off and 9.6v or so with key on and the fourth shows 0v at any time as it should being a data wire. So I am not sure what to do for hooking up my bypass module which is a xk04ford, the rs is a jkrs3 and it is going in a 2000 F150.
Where did you get this bypass module? And who is the manufacture? ------------- Ford Authorized Accessory Installer/Dealer
|