Print Page | Close Window

02 superduty diesel

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68164
Printed Date: May 10, 2024 at 9:18 AM


Topic: 02 superduty diesel

Posted By: stiverp
Subject: 02 superduty diesel
Date Posted: December 11, 2005 at 8:50 PM

 I've ran into a problem that has never occured. While using a tachless alarm/start system the truck would time out and start as it should, however after it would run for 5-10 seconds it would shut down the alarm would reset, timeout and restart the truck. This happens the 3 programed times and the truck shuts down the last time and system arms. I checked all wires over and over. Even tried hooking it up on the tach/rpm program still the same thing happens. This truck doesn't have pats. Does anyone out there have any ideas that I may have missed. I used the green wire on the back of the insturment cluster as I always do.  thanks, Stiver



Replies:

Posted By: customak47
Date Posted: December 12, 2005 at 1:12 PM
under the dash there is a factory harness wrapped with a piece of yellow tape to the left of the steering column called the body acceccory harness used for commercial applications that has a tach wire in it. (green also) that's the tach source i always use. try taking the fuses out of the unit or unplugging it altogether and let it reset, try reprogramming tach to that wire. if this doesn't work it's a defective module, bad ground, or bad install, because these are the easiest vehicles to do, in my opinion

-------------
My rifle is my friend...




Posted By: 5150azn
Date Posted: December 12, 2005 at 2:32 PM
How would you use tach on a diesel vehicle.

-------------
Tell the Snap-On guy I'm not here!




Posted By: rayrobson
Date Posted: December 13, 2005 at 1:00 AM

Here in Canada the wire is sometimes WHITE/ green or GREEN / WHITE in the same aux location. If for some reason you cannot find this tach wire you can purchase a tach generator from a number of suppliers. I agree with custom, these are straight forward installs so check your wiring and do yourself a favour... alaways program tach on a diesel.

Hope this helps.



-------------
H2s H3s Escalades Denalis all day everyday....if you need help with these vehicles PM me...If I don't know I will find out!




Posted By: KarTuneMan
Date Posted: December 13, 2005 at 1:06 AM
Thge tach is in a factory bundled harness under the dash .....left side of stearing column. GREEN / WHITE....reduce the crank time.....K

-------------





Print Page | Close Window