Print Page | Close Window

94 Altima Remote Starter Issue

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68260
Printed Date: May 03, 2024 at 3:43 PM


Topic: 94 Altima Remote Starter Issue

Posted By: mb07
Subject: 94 Altima Remote Starter Issue
Date Posted: December 12, 2005 at 10:56 PM

Everything is hooked up and working but Ignition and Second Ignition both do not turn on the heater and fan inside the car.  Any tips on this? 



Replies:

Posted By: silvercivicsir
Date Posted: December 12, 2005 at 11:17 PM

did you hook up the accessory ?




Posted By: mb07
Date Posted: December 12, 2005 at 11:22 PM

yup.  i threw a compustar in there which wants accessory, ignition and second ignition i used that realy it comes with just like every other car but this one particular car is just getting on my nerves.  maybe i should re check the accessory?  but the car is remote starting no problem its just the heat isnt coming out till the key is in there and turned etc.




Posted By: dmielken
Date Posted: December 13, 2005 at 11:29 AM
What color wire did you power for accessory? Normally when the heater doesn't come on it's a case of the accessory wire linked to it not being powered. Should be Red coming from keyside to a connector, after the connector it should be BLACK/ Red.



Posted By: thepencil
Date Posted: December 13, 2005 at 12:28 PM
Accessory is RED to BLACK/ pink.


You will need to set the jumper to second STARTER not ignition.


Follow the diagram below to connect the accessory wire.   


1077.pdf








|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |
|              12V|wht/red to white    |+ |ignition harness            |
|          STARTER|blk/yel to blk/wht |+ |ignition harness            |
|   SECOND STARTER|blk/grn to blk/yel |+ |ignition harness            |
|        IGNITION|blk/wht to blk/red |+ |ignition harness            |
|        ACCESSORY|red to BLACK/ pink *1|+ |ignition harness            |
|       POWER LOCK|gray/blue           |- |at door lock timer *2       |
|     POWER UNLOCK|gray/red            |- |at door lock timer *2       |
| PARKING LIGHTS +|RED / blue            |   |steering column             |
| PARKING LIGHTS -|                    |   |                            |
|       HEADLIGHTS|RED / blu,RED / yel *3 |+ |steering column             |
|     DOOR TRIGGER|RED / white           |- |drivers kick panel          |
| TRUNK/HATCH PIN|red                 |- |at right hinge, *4          |
|        HOOD PIN|yellow/black        |- |at pin or *4               |
|TRNK/HTCH RELEASE|                    |   |                            |
| FCTRY ALARM ARM|lt. GREEN/ red       |- |harness from dr. door       |
|FCTRY ALRM DISARM|GREEN/ YELLOW        |- |harness from dr. door       |
|       TACHOMETER|green               |   |coil or ECU center dash     |
|       BRAKE WIRE|RED / green           |+ |brake pedal switch/dkp      |
|     HORN TRIGGER|GREEN / WHITE        |- |steering column             |
|           WIPERS|                    |   |                            |
| LF WINDOW UP/DN|blu/blk - blu/red   |A |in the L.F. door            |
| RF WINDOW UP/DN|blu/blk - blu/red   |A |in the R.F. door            |
| LR WINDOW UP/DN|blu/blk - blu/red   |A |in the L.R. door            |
| RR WINDOW UP/DN|blu/blk - blu/red   |A |in the R.R. door            |


Notes:
*1 When doing remote start, this wire must be isolated from the keyswitch with the accessory relay. See direct fax document #1077.    *2 Timer is a blk or grn box located right of fusebox behind a silver module or up high in the drivers kick behind a silver module, depending on model. Two plugs, white and black. The wires needed to control locks are in the black plug. *3 these colors are for low beam. to catch high beam use RED / black(+) and RED / green(+). *4 also found at the theft warning system in the drivers kick behind the ABS control unit if equipped with factory security.



-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image



Posted By: mb07
Date Posted: December 13, 2005 at 11:06 PM
sorry you lost me there..set the jumper to the second starter wire? 



Posted By: chris354
Date Posted: December 14, 2005 at 12:15 AM
That car has only 1 acc and 1 ign. it has a second starter but that should not effect the heater. Turn the ign. to acc psition then check the remote start wire to see if has power on it . If you dont then redo the connection for the acc wire. Also while testing the acc wire try remote starting and see if the unit is putting out an acc.



Posted By: thepencil
Date Posted: December 14, 2005 at 12:49 PM
"sorry you lost me there..set the jumper to the second starter wire?"

Connector #8

Open up the module by sliding the cover back. Where you cut the green jumper wire for (automatic transmission installation) you will see three sets of pins. They will be mark. STARTER, ACC, IGN.

-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image



Posted By: mb07
Date Posted: December 14, 2005 at 11:21 PM
but leave my wiring as it is?



Posted By: thepencil
Date Posted: December 15, 2005 at 9:39 AM
Yes.

-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image



Posted By: mb07
Date Posted: December 17, 2005 at 3:06 PM
got it.  It was hooked up to the wrong accessory wire.  Everythings good now.  Thanks again everyone


Print Page | Close Window