Security light Trailblazer

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68286
Printed Date: May 06, 2025 at 3:03 PM

Topic: Security light Trailblazer

Posted By: uffdog
Subject: Security light Trailblazer
Date Posted: December 13, 2005 at 1:25 PM

Just installed a remote start on 2003 Trailblazer

Problem: Security light stays on , any ideas how to get it off?

I originally started with a passlock dip switch model and cut pass lock wire, changed over to a Data bus gmdl-bp, resoldered the pass lock wires and now the security light is staying on as I drive.

Using an Astra 1000 RS, so far the RS is working fine , I just want to get the security lifght off, tried using a scan tool no luck.

any Ideas? email Ruffdog@AOL.com

-------------
RFD

Replies:

Posted By: kgerry
Date Posted: December 13, 2005 at 1:36 PM

i know the XK01 has updated software for the security light issue.....

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979

Posted By: uffdog
Date Posted: December 13, 2005 at 1:41 PM

I don;t believe it's the bypass, while waiting for new gmbp-dl to arrive I had the issue after disconnecting the dip switch one, wondering if by soldering wire back together if I changed resistance in the wire and computers not reading it

-------------
RFD

Posted By: Geeque
Date Posted: December 13, 2005 at 2:18 PM

Did you cut the wire with ignition key in the on position?

-------------
Gary Kline
MECP Master Technician

Posted By: uffdog
Date Posted: December 13, 2005 at 2:36 PM

I don't remember lets say i didn't have it in the on position?

-------------
RFD

Posted By: chris354
Date Posted: December 13, 2005 at 6:49 PM

According to dei website under testing the passlock2 if the light is on solid must be reset by dealer. I have never personally had it happen to me so not for sure.

Posted By: uffdog
Date Posted: December 14, 2005 at 7:46 AM

Ok I was able to troubleshoot the problem, I disconnected battery for 10 min and reprogramed the databus Bypass and it cleared the problem.

Light is now out, Thanks to all those guys that responded, you guys are an asset to this site and I hope I can return the favor someday

RFD

-------------
RFD