Print Page | Close Window

2001 mercury villager alarm wiring

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68523
Printed Date: July 14, 2025 at 6:32 AM


Topic: 2001 mercury villager alarm wiring

Posted By: jscooneys
Subject: 2001 mercury villager alarm wiring
Date Posted: December 16, 2005 at 12:46 PM

hey i work at a car lot and need the wiring for this villager so if anyone can help that would be great

thanx



-------------
wokin4alivin



Replies:

Posted By: another-kelly
Date Posted: December 16, 2005 at 5:17 PM
MERCURY  VILLAGER  2001
12volts WHITE/ red   +  ignition harness
Starter BLACK / YELLOW   +  ignition harness
Second Starter BLACK/ green   +  ignition harness
Ignition BLACK/ white   +  ignition harness
Second Ignition     
Third Ignition     
Accessory blue   +  ignition harness
Second Accessory red   +  ignition harness
Keysense     
Power Lock red   -  either door harness
Power Unlock RED / black   -  either door harness
Notes: Unlock requires double pulse.
Lock Motor GREEN/ YELLOW    drivers door harness
Unlock Motor WHITE/ green    drivers door harness
Parking Lights+ do NOT use    
Parking Lights- gray/red    headlight switch
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger    -  
Notes: Low in the drivers kick find red for the drivers door and RED / white for the liftgate. In the passengers kick find RED / white for the passenger front door, and RED / green for the sliding doors. Use all trigger wires and diode isolate each.
Dome Supervision BROWN / white   -  low in drivers kick
Trunk/Hatch Pin with door trigger    
Hood Pin BLACK/ pink   -  harness behind fuse box
Trunk/Hatch Release     
Power Sliding Door     
Factory Alarm Arm arms with lock    
Factory Alarm Disarm disarms with unlock    
Disarm No Unlock     
Notes: A single pulse on the unlock wire will disarm the factory alarm without unlocking.
Tachometer white    pin 2 @ PCM
Notes: The PCM is located behind the glove box.
Wait to start     
Brake Wire yellow/black   +  brake pedal switch
Parking Brake     
Horn Trigger lt. blue/black   -  steering column
Memory Seat 1     
Memory Seat 2     
Memory Seat 3     
posted_image
Interface Module:Category:
Immobilizer Bypass
Required:
No
Type:
N/A





Print Page | Close Window