GMDL-BP arms and locks doors on shutdown
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68656
Printed Date: May 10, 2025 at 11:06 PM
Topic: GMDL-BP arms and locks doors on shutdown
Posted By: skewdrv
Subject: GMDL-BP arms and locks doors on shutdown
Date Posted: December 18, 2005 at 4:58 PM
Has anyone had any issues with GMDL-BP on new Silverados and suvs? I have installed 3 this weekend on everyone of them if you shutdown with remote or disable with key & brake and turn the key off. It would lock the doors and arm the factory alarm even with key in switch!. Its not comming from the rs lock wires I clipped them. I can unplug the gmdl before turning off the key and it doesn't arm the alarm. So it must be the gmdl doing this. All of the modules are new one's dated 11/05 did they change something? I have never had any issues with them before. Is there any way of shutting this off. I tried grounding the alarm disable wire after shutdown but a few seconds later it turns around and rearms and locks
Replies:
Posted By: mo12v
Date Posted: December 18, 2005 at 5:52 PM
Are you using the ORANGE wire on the GMDL?? ------------- MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
Posted By: skewdrv
Date Posted: December 18, 2005 at 6:02 PM
no, Im just using green,blue,brown,red,blk,purple but I unhooked the grn & blue to make sure the rs was not locking the doors
Posted By: uffdog
Date Posted: December 18, 2005 at 9:26 PM
I have the same problem, isn't the orange wire for panic on the factory alarm system? On the GMdl-bp the directions say not to hook up pink/wht and wht/pink unless using a combo alrm/rs I just installed a Rs and other than the locks locking after shut down, it works fine,I think this may be a programing issue in the RS am i right? ------------- RFD
Posted By: mobile1
Date Posted: December 18, 2005 at 11:45 PM
did you try hookiing up your fact. disarm to the PURPLE / white?
Posted By: skewdrv
Date Posted: December 19, 2005 at 4:27 AM
I have tried that too:( It waits about 10 secs after shutdown when the radio shuts down after that you see the sercurity light come on on the dash and and the doors lock.
Posted By: gus1
Date Posted: December 19, 2005 at 5:46 AM
Disarms when it sees the ground when running come on, and arms/locks when it sees ground when running go away with the ignition off. Pretty sure every data style doorlock bypass box behaves this way......
Gus
PS: GMDATAALL, 457G, also do this....
-------------
Wherever I go, that is where I end up......
Posted By: airandsound
Date Posted: December 19, 2005 at 12:34 PM
I thought that was normal,, didn't try it with the key in the switch though.
Posted By: sparkie
Date Posted: December 19, 2005 at 8:07 PM
The software in the GMDL-BP is designed to secure the vehicle after remote shut-down. It sends a data message to the vehicle to simulate opening the door to shut off the retained accessory power to the radio and to allow the factory alarm to arm. It also locks the doors to finish off the arm cycle for the factory alarm. Most of the newer data modules do this as default in their software. It can be annoying at times, but it is done to reduce the stupid human factor. This way you don't have to remember to lock your doors and your alarm will also arm automatically.
-------------
sparky
|