I installed a STARTNR2 add on remote starter to my factory keyless entry on my 2002 Acura RSX. I have run into two problems:
1. The keyless entry is deactivated by the ignition input when the car is started, so I cant unlock my doors after remote starting. I have heard a relay can be used to interrupt this ignition input. Does anyone know how this would be done? I dont know where the keyless entry module is or whether the input signal is negative or positive.
2. I am running the ACC 2 negative output from the starter to trigger the bypass module and the clutch switch, but for some reason the output is dropping from 12 volts to 0 when the starter is triggered. I was told that this is because I have two places running off of the same wire. How do I keep the clutch from dropping out, My car wont start without the clutch switch getting the 12 negative volts.
Any help would be greatly appreciated!
Not sure on the first question but on #2 the acc will drop out during crank. You need to use an ign. or see if you can program that unit for acc on during crank. Also can use the status out or groung while running output.
Ive got #2 fixed, but I still need to find a way to unlock the doors after the car has started. I figured out that there is a safety feature where the keyless entry is disabled as soon as the key is slid into the ignition. I need to find the wire that goes from here to the keyless entry, but I have no idea where to look.?