Print Page | Close Window

APS 686t in 02 Sante fe

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=68692
Printed Date: May 15, 2025 at 9:33 PM


Topic: APS 686t in 02 Sante fe

Posted By: shmoove77
Subject: APS 686t in 02 Sante fe
Date Posted: December 19, 2005 at 2:10 AM

Having a little problem...just finished install on vehicle..when I go to use the remote start the starter seems like it does not wnat to disengae and it shuts off...then trys to fire back up with the same results....any suggestions ?? Also for the park lamps on this vehicle should there be 12v constant ran to the unit and the other wire to the headlamp switch.??

Thank you



-------------
Shawn



Replies:

Posted By: Mike M2
Date Posted: December 19, 2005 at 6:33 AM
It sounds like you have the wrong tach wire, or it's not programmed. It should be WHITE/ black or blue at the ECM. The lights are GREEN/ orange at the fuse box. One white wire goes to that, the other to 12volts.

-------------
Mike M2
Tech Manager
CS Dealer Services



Posted By: shmoove77
Date Posted: December 19, 2005 at 12:04 PM

Will it go into program mode if the park lamps are not hooked up ???



-------------
Shawn


Print Page | Close Window